RCU Designs, Inc.

Handlebar Risers
ecommerce070002.gif arrownext.png arrowprev.png
RCU 06060
These Risers offer 1-3/4" of rise and 1/2" set-back. Original OEM brake and clutch lines should be adequate. (Sometimes there are variations in line lengths on the same models.)
Handlebar Risers can significantly change the angle of the driver's back and relieve stress on the wrists. All parts are manufactured from aircraft quality 6061 aluminum alloy and are black anodized. The OEM handlebar top clamps are reused. Fasteners are black-zinc plated to resist corrosion. There are no holes to drill. Each Riser Set includes all necessary hardware, mounts and installation directions. Note: F800GS Riser installation shown. F650GS is typical.
NOTE: After installing Risers, it is mandatory to fully check for proper control operations in full left and right lock steering positions.
Page 70 of 97
See Home Page for a limited time special end-of-inventory clearance sale!!